better and more comfortable camping, and to spend more days while you are traveling and supplying you with portable hot water shower all time. As a result, you can make a portable shower by yourself and in an easy way; just follow the following article to learn how to install an instant 

heater inside a box that you can carry in everywhere.

How can you make a portable shower in a box by yourself?

First of all, you have to choose an appropriate heat-resistant box seventeen and a half inches high and twelve inches wide. But it's better to have much depth because there is a lot of things that will be put in; such as, the heater, shower, head shower, the water hose, and the gas hose…etc.

 Then you have to drill two holes about a quarter of an inch to install the heater on them inside the box, make sure that there are brass fittings at the bottom to avoid corrosion.

 As well as you will use yellow Teflon tape besides half-inch PSPP fittings to screw both those clockwise with the gas connections. In addition to that does not forget to place the batteries on its case in their correct directions. And then after you've installed all the connections down the heater, you must install the heater above and below the box.

 Then you can get a 12V pump with a pair of bare wire pumps and hook this with the solder, coil this all up, and shove it in the box when close it up. Moreover, attach two hoses with the pump and then install the pump inside the box at the edge not on the center because of the heater's curve, and attach the first hose with a filter; because the cold water comes through it onto the pump 12- volt fuel carrier and drops the other hose onto the water input power.

Abstraction:

  So cold water goes into the bottom and comes out the hot water, also the heater contains gas plugs. Then bring a showerhead and a hose that comes with the shower set up and supplied with an On/Off switch; as a result, this will not waste the gas or water.

 Almost everything is ready for camping, after joining all the connections and put the showerhead, gas hose, water hose, and power lines inside the box. jakhary 500 machine will run this process, it has got 12 Volt outlet and it uses about 23 watts as the pump, and it would be used for more 22 hours or less. Furthermore, when open the box, there is will be a plug-in of the gas, plug in the shower hose, and plug in the showerhead.

The mechanism of the portable shower:

 The pump will turn on and press the entire system and then using the showerhead to press ON position. Then immediately the water starts to go out, already the cold water takes a few seconds to heat up, and if you leave it for a while; the water in the hose will cool.

Make your life much easier and go camping or travel while you are comfortable, and make your own shower by yourself. Read this useful article, because this is a simple process.